Q: Can't get EvoScan and EcuFlash working with the Limitless.co.nz USB Cable. A: I did un-install and re-install with the EvoScan 2.5 ftdi drivers on my laptop #2, and both EvoScan and EcuFlash are now working! But with my laptop #1, i didn't do a single thing, except that I did drive my car for half day right before doing it. So, I think the real trick...is due to the voltage in the battery. In my conclusion, check and make sure your battery is good and above 12.5v before logging a support call.
Q: When I am logging at Wide Open Throttle, the logging file cuts out. What is causing this? A: Most likely you have hard drive protection enabled i.e hard drive stops spinning due to g-force. there is now a 30 second buffer in evoscan v2.7 which helps a lot with this.
Q: Does Openport 2.0 work with ACD? A: Not currently tested, but we are working on it.
Q: Does AYC logging work in v2.5?
A: There is reports of AYC not working for Evo7/8/9 (only working for EVO4/5/6 with Op1.3U w/ no pin9 cables)
Q: Does AYC logging work in v2.6?
A: There is reports of the AYC logging not working at all in v2.6, hopefully will be fixed in v2.7
Q:
Q: Where can I download .net Framework 1.1 and 2.0? A:
Q: Where can I download previous versions of EvoScan?
A:
Q: MUT over OBDII is not longer working in v2.6?
A: There is reports of this not working, yes this is now fixed in v2.7
Q: My AEM wideband (WDB) logging freezes on the same value after 4 or 5 seconds? A: There is reports of AEM logging freezing in v2.6, I currently own an AEM and have fixed the issue in v2.7 and it runs silky smooth now, let me know if you any further issues.
|