|
Reflashing Mitsubishi 2006 4G15 Ralliart Colt RG |
 |
 |
 |
|
Reflashing your 2006 Mitsubishi Colt 1.5L Turbo 4G15
• MMCFlash supports MH8304F
• UPDATE: 20 December 2011, the same pins for 2005 Mitsubishi Colt CZT 1,5 Mivec 4G15T - MH8105F (1.5L Turbo)
• UPDATE: 23 November 2011, the ecu is MH8304F, and is reflashable via MMCFlash. see here for details.
• UPDATE: 20 October 2011, the CANbus ecu pins 105&106 6H&14L are not actually used on this ecu. even though the Mitsubishi documentation has provisions of the CAN bus on those ecu pins.
• Smart For Four also might have this ecu
Colt
ECU Pin | OpenPort 2.0 Cable | 12v-15v Power Supply (use a Laptop Power supply if you like, check the voltage) | Description |
pin 75
|
pin 4 and/or pin 5 |
Negative/Ground (-) |
Vehicle Chassis / Battery Terminal (-) |
| pin 77 |
pin 16 |
+12v |
|
| pin 82 |
pin 16 |
+12v
|
|
| pin 122 |
pin 16 |
+12v |
|
pin 136
|
OpenPort 1.3U or OP2.0 reflash connector.
(OBDII 11)
|
Reflash init line
|
Reflash Init. Voltage from ext. mitsi reflash connector on the OpenPort 2.0 cable.
Speaker jack "tip"
pin1 from the ecu also feeds through to the Pin 11 on the vehicle OBD2 Connector.
Pin 136 from the ecu also feeds through to the Pin 11 on the vehicle OBD2 Connector. So just pop pin11 out of the OBDII port and connect it to the 12pin openport 2.0 single reflash wire.
|
pin 121
|
pin 7
(OBDII 7)
|
K Line
|
K Line Data (used for recovery mode ecuflashing) Pin 121 from the ecu actually comes through to pin 7 on the OBDII vehicle connector. |
xmlid: read_mitsum32176f6boot
make: Mitsubishi
market: ALL
model: Colt
submodel: (768k)
year: 2006+?
flashmethod: mitsubootloader
memmodel: M32176F6
Read ROM:
|
|
Last Updated on Monday, 23 April 2018 08:56 |
